26 GB
Both alarm symbols will appear: . Pressing the DOWN- /
button a fourth time will deactivate both alarm 1 and alarm 2.
Switching off the alarm
The alarm will sound at the set time and the backlight will switch
on. When not switched off, the alarm will sound for 2 minutes
before stopping automatically.
Press the SNOOZE-/LIGHT field
2
to interrupt the alarm. The clock
display will flash
, indicating the snooze function has been
activated: the alarm will sound again after 5 minutes.
Press any button on the keypad to actually shut off the alarm.
Accessing stored data
Maximum temperatures
Press the MEM button
13
nagain and both temperature fields will
show
22
and
23
next to the temperature, and MAX next to the humid-
ity. The respective maximum indoor and outdoor value will be shown.
Press the MEM button twice and MIN will appear next to the temper-
at
ure, and the respective lowest indoor and outdoor value will be sho
wn.
After 5 seconds the current values will again be displayed.
TIP: Min / Max Temperature are measured by all time since start
(after batteries inserted / power supply connected). To erase the
stored Min / Max Temperature, hold the MEM button for approx.
3 seconds.
Barometric pressure history
Repeatedly briefly pressing the SET-/HISTORY button
7
will display
the barometric pressure for the past 12 hours. The barometric pressure
field
25
next to the display of the barometric pressure the history
indicates how many hours ago the barometric pressure being displayed
was current.
To Next Page
Loading...
Need help?
General
