OWIM Z31482A - Mounting the Device on a Wall

71 GB/MT
from the screw
13
. To do this hook the
hanger
11
of the indoor / outdoor ther-
mometer on to the screw
13
.
Q
Mounting the device
on a wall
Pull the protective foil from one of the
sides of the self-adhesive pad
14
.
Stick the self-adhesive pad
14
on to the
back of the device.
Pull the protective foil from the other side
of the self-adhesive pad
14
.
Take the device to the desired location
and press it carefully on to a wall or other
smooth surface.
Note: Wait 24 hours after installation until
using the device. This is to allow the self-adhe-
sive pad
14
to achieve an optimum level of
adhesion. After installation, do not change the
position of the self-adhesive pad
14
, otherwise
the level of adhesion achieved by the self-
adhesive pad could be reduced.