4.4 Sensor
The Sensor has light emitters and a detector which measures Pulse Rate, Oxygen Saturation and movement. This data is sent to the
Base Station via Bluetooth.
For the Sensor to function properly, it is positioned and held in a specific location on the foot by the Sock (see Section 6.1) .
NOTE: Pairing associates a Base Station and new Sensor. If the Sensor is replaced, you will need to repeat the pairing
process to pair the new Sensor to the Base Station. Contact Customer Support for assistance.
Sensor Features
The Sensor has a dome-shaped body with the Owlet logo on it. Attached to the Sensor is a flexible fabric strip with the light emitters
and detector. This flexible fabric portion curves around the baby’s foot, placing the light emitters opposite the detector.
Measurement Light Emitter
Shines LED light through the foot to allow the Sensor to receive accurate readings.
Measurement Light Detector
Collects readings.
Sensor Dome/Magnetic Charging
Connects to the Base Station for charging.
Sock Notch
Aids alignment of the sensor to the Sock.
To Next Page
