The Sock and/or Sensor should be replaced if:
● The Sock is stretched out, the fabric is separating or has holes or rough spots.
● The fabric or Sensor windows are ripped, warped, or otherwise damaged.
● The fastener has been worn and no longer latches properly.
● Multiple cleanings fail to remove visible stains/dirt.
For information about replacing the Sock see Section 14 .
8.3 Cleaning the Base Station
The Base Station should be cleaned:
● When visibly soiled
● At least once every 2 weeks
1. Turn off monitoring and unplug the Base Station. (Section 9.4 Turning the Sensor Off)
2. Moisten a soft cloth with a mild cleaning solution.
3. Wipe the Base Station with the damp cloth.
4. Wipe the Base Station dry or allow it to air dry.
CAUTION. Use cleaning solutions sparingly to avoid getting any liquid in the Base Station enclosure.
9. Maintenance
Dream Sock contains no user-serviceable components, and no calibration is required. Routine maintenance includes:
● Inspecting the device for damage and cleanliness NOT use if the device appears damaged.
● Cleaning the device according to the cleaning instructions found in Section 8 .
9.1 Sensor Battery Maintenance
The Sensor battery is non-replaceable and can’t be serviced. Sensor battery performance can decrease with age and use. If a fully
charged Sensor will not operate for at least 8 hours, it should be replaced.
To Next Page
