2. Operation Guide2. Operation Guide
2.2 Editing
2.2.3 Erase All Programs
2.2.4 Clear a Scene or Scenes
1. Press and hold the Record button.
2. Tap the Flash buttons 1, 4, 2 and 3 in sequence while holding the Record
button. All LEDs will flash, indicating all programs stored in memory have
been erased.
RECORD STEP
DELETE
1 4 2 3
+
1. Record enable.
2. Record a scene or scenes.
3. If you are not satisfied with the scene or scenes,
you may tap the Rec Clear button while pressing
and holding the Record button, all LEDs will flash,
indicating the scenes have been cleared.
RECORD
REC
CLEAR
RECORD
REC
EXIT
2.2 Editing
2.2.5 Delete a Step or Steps
1. Enter the Edit mode.
2. Tap the Step button to scroll to the step you
wish to delete.
3. Tap the Delete button when you reach to the
step you wish to delete, all LEDs will flash
briefly indicating the deletion of the step.
4. Continue steps 2 and 3 until all the unwanted
steps have been deleted.
5. Tap the Rec Exit button while pressing and
holding down the Record button, the Scene
LED goes out, indicating the exit of Edit mode.
1413
To Next Page
Loading...
Need help?
General