2. Operation Guide2. Operation Guide
2.3.1 Running Chase Programs
2.3.2 Running a Program To Audio
2.3.2 Running a Program To Audio
2.3.3 Running a Program With the Speed Slider
4. Move the desired Channel slider (13-24) to its
maximum position to trigger the program, and
the program will fade in depending upon current
fade time.
You may press and hold down the relevant Flash
button(13-24) to trigger the program.
5. Move the Channel slider to adjust the output
of the current program.
1. Use built-in microphone or plug the audio source
into the RCA Audio jack.
2. Select your program as described above.
3. Tap the Audio button until its LED lights, indicating
Audio mode is active.
AUDIO
AUDIO
AUDIO LEVEL
4. Use the Audio Level slider to adjust the music
sensitivity.
5. To return to normal mode, tap the Audio button
a second time causing its LED goes out, the
Audio mode is disengaged.
1. Be sure the Audio mode is disengaged, that
is, the Audio LED goes out.
2. Select your program as described above.
3. Move the Speed slider to the SHOW MODE
position(the bottom), then tap the Flash button
(13-24) while pressing and holding down the
Rec Speed button, the corresponding program
will not run with the Standard beat any longer.
2019
REC SPEED
FLASH 13-24
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
10
8
6
4
2
0
To Next Page
Loading...
Need help?
General