Unpack your fan and check the contents. Do not discard the carton. If warranty
replacement or repair is ever necessary the fan should be returned in original packaging.
Remove all parts and hardware. Do not lay motor housing on its side - because the
decorative casing may shift. Check all visible screws, bolts and nuts for tightness.
Examine all parts. The following parts should be included:
2. UNPACKING YOUR FAN
NOTE:
Some Oxygen fan models will have slightly
different parts than what is shown here
depending upon the design you have chosen.
Basic installation procedures are similar for
all models.
IF YOU FIND THAT PARTS ARE MISSING. CONTACT YOUR DEALER FOR REPLACEMENT, OR CALL OXYGEN DIRECTLY AND WE WILL MAIL REPLACEMENTS TO YOU IMMEDIATELY.
1. To avoid possible electric shock, turn
off the electricity at the main fuse box or
circuit panel before you begin the fan
installation or before servicing the fan or
installing accessories.
2. Read all instructions and safety
information carefully before installing
your fan and save these instructions.
3. Make sure all electrical connections
comply with local codes or ordinances as
well as the National Electrical Code. If
you are unfamiliar with electric wiring,
please use a qualified and licensed
electrician.
4. Make sure you have a location
selected for your fan which allows clear
space for the blades to rotate, and at lease
seven (7) feet of clearance between the
floor and the fan blade tips.
5. The outlet box and ceiling support
joist used must be securely mounted, and
capable of supporting at least 50
pounds. To reduce the risk of fire,
electric shock, or personal injury, use only
an outlet box clearly labeled "Acceptable
For Fan Support".
6. To reduce the risk of personal injury
use only approved hanging brackets and
screws supplied with the outlet box for
mounting to the outlet box.
7. After installation is complete, check
that all connections are absolutely secure.
8. Do not insert anything into the fan
blades while they are rotating.
9. To operate the reverse function on the
fan, press the reverse button on the wall
transmitter while the fan is running.
10. Do not attempt to control the
operation of the fan (or an optional light
kit) from any wall control that is not
approved by Oxygen for use with its fans.
Do not use solid state wall controls. The
use of any unapproved control voids the
fan's warranty.
1. SAFETY RULES
TOOLS REQUIRED
FOR INSTALLAITON
Phillips Screwdriver
Wire Cutters
Electrical Tape
Step Ladder
Model #3-101-xx: 17.64 lbs
1. Set of blades (a)
2. Blade support plates (b)
3. Hanging bracket (c)
4. Canopy (d)
5. Canopy cover (e)
6. Downrod assembly (6"+4") (f)
7. Yoke cover (g)
8. Fan motor assembly (h)
9. Mounting plate (i)
10. Decorative cover support plate (j)
11. Decorative cover (k)
12. Receiver (l)
13. Wall transmitter w/2 mounting screws and 3 wire nuts,
Wall plate w/2 machine screws (m)
14. Parts bags (n) containing:
Blade attachment hardware
(Screws/washers, washers may be attached to screws, fiber
washers.)
Mounting hardware
(wire nuts, wood screws, machine screws, lock washers,
spring washers, metal washers.)
15. Blade balancing kit (o)
a.
b.
c.
d.
e.
h.
g.
f.
j.
i.
k.
l.
m.
0.
n.
To Next Page
Loading...