Fig. 7
Downrod
Hanger bracket
WARNING -Turn off the power!
DO NOT fasten the blades to the fan until
it is assembled and hanging from the
ceiling. To do so now will likely bend the
blade arms and almost certainly cause
wobble.
1. If not already affixed to the hanger
bracket, place the rectangular rubber isolators
between the hanger bracket and outlet box.
Secure the hanger bracket to the outlet box
using the 2 long steel screws supplied with
the outlex box.
2. Remove the set pin and safety lock clip
from the yoke on top of the motor assembly.
Slide the downrod through the canopy and
canopy cover. Slide the yoke cover onto the
downrod (Fig. 5). Feed the wires from the
fan motor through the downrod assembly.
3. (Fig. 6) Attach the downrod assembly by
feeding the wires through the yoke cover,
canopy cover, canopy and downrod
assembly. Insert the downrod into the yoke.
Slide the set pin through the yoke and
downrod and secure with safety lock clip.
Tighten the screws on yoke. Lower the yoke
cover to conceal the yoke.
4. Lift the fan motor without the blades and
place into the hanger bracket, rotating the
ball until the groove engages the tab on the
hanger bracket. This locks the ball mount
and fan motor, preventing fan rotation during
operation. (Fig. 7)
4. HANGING YOUR FAN
Fig. 5
Fig. 6
Downrod
Set screw
Safety
lock clip
Set pin
Canopy
Canopy cover
Yoke cover
Yoke
Downrod
assembly
Ceiling
canopy
Canopy
cover
Yoke cover
To Next Page
Loading...