Oxygenics PowerMax - User Manual

EASY INSTALLATION
INSTRUCTIONS
STEP 1
Remove your
existing shower
head. To remove,
turn the existing
shower head in a
counterclockwise
direction.
STEP 2
Remove any
remnants of old
plumber’s tape
and flush out
shower pipe for
5 to 10 seconds.
STEP 3
Wrap plumber’s
tape clockwise
3 or 4 turns
around threaded
end of shower
arm.
STEP 4
In a clockwise
direction, screw
handheld holder
onto the taped
portion of shower
arm. Hand
tighten only.
STEP 5
Attach hex nut
end of hose to
holder and hand
tighten.
STEP 6
Attach conical
nut end of hose to
handheld shower
and tighten. Insert
your new handheld
shower in holder.
STOP!
NEED HELP?
PLEASE DO NOT RETURN THIS
PRODUCT TO THE STORE.
If you need installation assistance, replacement
parts or have questions regarding our warranty
please contact customer service at
1.866.440.9257
or 1.775.420.5600
Support is also available via email at
support@oxygenics.com
Be sure to visit our website at
www.oxygenics.com
Business Hours:
Monday-Thursday 7:00 am to 5:00 pm PST
Friday 7:00 am to 4:30 pm PST
EASY TWIST SPRAY
SELECTION
Enjoying multiple spray
patterns during your
shower has never
been easier. With the
PowerMax’s easy twist
design, simply rotate the
easy spray selector for a
quick spray change.
USING THE COMFORT CONTROL
Located on the back of the shower head, the comfort control
regulator eliminates sudden blasts of water. Note: The comfort control
is not a shut off valve. When turned to the lowest position, the shower
head continues to flow. This is a normal safety feature. Unit may be in
lowest flow position during shipping. Check the position of comfort control upon installation.
ATTENTION:
WASHERS
PRE-INSTALLED
IN HOSE ENDS
Washers must be inserted
into both hose ends for
proper installation.
PowerMax
For use with automatic
compensating valves
rated at 1.50 GPM
(5.68 L/min) or less.

Summary

OxyGenics PowerMax Easy Installation Instructions

Step 1: Remove Existing Shower Head

Remove your existing shower head by turning it counterclockwise.

Step 2: Clean Shower Pipe

Remove old plumber's tape and flush the shower pipe for 5-10 seconds.

Step 3: Apply Plumbers Tape

Wrap plumber's tape clockwise 3-4 turns around the shower arm's threaded end.

Step 4: Install Handheld Holder

Screw the handheld holder onto the taped shower arm clockwise and hand tighten.

Step 5: Connect Hose to Holder

Attach the hex nut end of the hose to the holder and hand tighten.

Step 6: Connect Hose to Shower Head

Attach the conical nut end of the hose to the handheld shower and tighten.

Easy Twist Spray Selection

Spray Pattern Adjustment

Rotate the easy spray selector to quickly change shower spray patterns.

Attention: Washers Pre-Installed in Hose Ends

Washer Installation Requirement

Washers must be inserted into both hose ends for proper installation.

Using the Comfort Control

Comfort Control Operation

Regulator on shower head back controls water flow, not a shut-off valve.

Need Help? Contact Support

Customer Service Contact Information

Contact customer service via phone or email for assistance, parts, or warranty questions.

Oxygenics PowerMax Specifications

General

Brand	Oxygenics
Model	PowerMax
Finish	Chrome
Technology	Oxygenics
Water Pressure	20-80 PSI
Warranty	Lifetime