Ozito ECOMOW - OPERATION; Securing Power Cord; Grass Catcher Assembly; Fitting and Removing Grass Catcher

1
OPERATION
1. Make a loop with the extension
cord (socket end of cord) through
the loop and secure over the
hook.
2. Connect the mower power plug
into the extension cord socket as
shown.
The height adjustment lever provides 6 cutting heights from 20mm to
70mm.
1. Usingarmgrip,pulltheheight
adjustment lever outward. Adjust
until the required cutting height is
selected.
WARNING!: WHEN ASSEMBLING THE GRASS
CATCHER BACK TO THE MOWER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD
UP OF GRASS IN THE GRASS CHUTE. IF NEEDING TO
CLEAR THE GRASS, ALWAYS ENSURE THE MOWER
IS DISCONNECTED FROM THE POWER SUPPLY
PRIOR TO CLEARING. A BUILD UP OF GRASS IN THE
GRASS CHUTE MAY PREVENT GRASS FROM MOVING
INTO THE GRASS CATCHER EFFECTIVELY.
1. Secure the power cord from the
switch housing to the mower using
the two cord clips (supplied).
1. Assemble the two bottom halves
of the grass catcher together.
Align the two halves and push
each individual plastic lug into its
opposite location. Ensure that all
the plastic lugs engage correctly
together around the entire middle
section.
2. Assemble the grass catcher top
onto the bottom half of the grass
catcher assembled in step 1.
Align the two halves and push
each individual plastic lug into its
opposite location. Ensure that all
the plastic lugs engage correctly
together around the entire middle
section
WARNING!: DISCONNECT THE MOWER FROM
THE POWER SUPPLY AND ENSURE THE BLADE
HAS STOPPED COASTING BEFORE ADJUSTING THE
HEIGHT.
Securing the Power Cord to the Handles
“CLICK”
“CLICK”
Assembling the Grass Catcher
“CLICK”
“CLICK”
“CLICK”
“CLICK”
Fitting and Removing Grass Catcher
Using the Cord Retainer
HOOK
2. PREPARATION
Cutting Height Adjustment
The cord retainer prevents the extension cord from being disconnected
during use.
CAUTION: BE CAREFUL DURING CUTTING HEIGHT
ADJUSTMENTS OF THE LAWN MOWER TO PREVENT
ENTRAPMENT OF THE FINGERS BETWEEN MOVING
HEIGHT ADJUSTMENT LEVER AND THE MOWER
HOUSING.
3. Toemptythegrasscatcher,liftthecatcherapwithonehand
then lift the grass catcher with the other hand up off the two raised
housing clips.
The catcher must be attached to the two raised hooks on the mower.
1. Liftupthecatcherapwithone
hand and guide the catcher over
the two hooks on the mower
housing.
2. Lower the grass catcher in place
andlowerthecatcherap.
Assemble the three sections of the grass catcher.
Grass Catcher Volume Indicator
To alert you that the grass catcher
is full, the mower provides a volume
indicator.
Indicatoroatsupwhenempty.
Indicator is down when full.
Empt y
Full