Ozito LTM-3000 - ROUTER BITS; Straight Bits; V Groove Bits; Round Over Bits

V GROOVE BITS
UsedtocreateVshapedchannelsorutesinaworkpiece.
ROUTER BITS
Below is a list of the router bits that can be used with this laminate trimmer.
This laminate trimmer is designed for use only with 1/4” (6.35mm) bits. The max diameter of the head of the bit should be less than
32mmtotthetrimmerbase.
FLUSH TRIM BITS
Suitedtotrimmingtheedgeofonepieceushwiththeedgeof
another piece. A common use is using a pattern or template to
create multiple identical shapes of the pattern.
ROUND NOSE BITS
SimilartotheV-groovebitinthatitcreateschannelsorutes
in a workpiece.
DOVE TAIL
Most commonly used to create tails for dovetail joinery. Plunge
cutsaatbottomwithangledsidesintoaworkpiece.
CHAMFER
Cuts a 45-degree angle on a square edge.
COVE BIT
Used to create a concave, rounded edge to a piece of timber.
Often used in conjunction with a round over bit.
ROUND OVER BIT
Creates a rounded edge on a piece.
STRAIGHT BITS
Straight router bits a ideal for making plunge cuts into a material
to form a groove or to hollow out an area for a mortise or inlay.