EasyManua.ls Logo

Ozone Forza - Care and Maintenance; General Care and Cleaning; Routine Inspection; Pod Replacement Procedure

Ozone Forza
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CARE AND MAINTENANCE
EN
18
17
TheForzawilllastyoumanyightsandmanyyearsiflookedaftercorrectly.Tokeepyourharnesscleanandairworthy,pleasenotethefollowing:
•AvoidexcessiveexposuretoUV,heatandhumidity.
•Packtheharnessdryandstoreinacooldryplace.
•Neverdragyourharness.
•Keepyouharnesscleanofdirt,oilsandanycorrosivesubstance.
•Usewaterandaclothtoclean.
INSPECTION
Forsafety,routineinspectionofallofyourequipmentisvitallyimportant.Ozonerecommendsaserviceintervalof12monthsinadditiontotheusual
preightchecks.
Forinspection,visuallycheckthestitching,webbingandallstructurallyimportantareas.Payparticularattentiontothewebbingaroundthehangpoint
areaunderthekarabiner,asthisiswhereabrasionismostlikely.
Ifyoundanydamageorifyouareinanydoubtmakesuretheharnesscheckedbyaprofessional.
REPLACING THE POD
ReplacementpodsareavailablefromyourOzonedealer.Itispossibleaftermanyhoursofuse,orafteranincidentthatresultsindamagethatthe
podrequireschanging.Toremovetheoldpod:
1. DisconnectthethinblackloopsfromtheCarabinners
2. Undobothzips(oneeachside)
3. TearthepodofftheVelcro.
4. Removethelongpurplelinesthatrunthroughthepulleysonbothsidesofthepod.
5. Disconnectthemaillonthatsecuresthespeedbartothefootplateelastic.
Replacing the pod is the reversal of the aboveprocedure. Use a larks foot to connect the pod lines and make sure the thin red pod loops are
connectedtothecarabiner(step1).Ensuretousetheredloops,theshorterblueloopsareforattachingthepodtoanOzium(1)structure.
IMPORTANT: Ensure that the red pod loops (1) are attached to the carabiners. Failure to do so will put excessive load
through the zip causing failure.
3. Velcro
2. Zips
1. Red pod loops on carabiners
4. Purple pod lines
5. Speed bar attachment
IMPORTANT: Ensure the red
pod loops (1) are attached
to the carabiners. Failure
to do so will put excessive
load through the zip causing
failure.

Related product manuals