Ozone Forza - Fitting and Adjustments; Harness Fitting and Initial Adjustments

FITTING
EN
12
11
Beforeyourrstight,werecommendtosuspendtheharnessfromasuitablystrongpointtocheckthat
ittsyoucorrectlyandtobecomefamiliarwiththefeaturesandadjustments.Youcansettheshoulder
adjustment-strapstondthebestt,andadjustthelumbersupportsothattheyleaveyouinacomfortably
reclinedposition.
Toputtheharnessonrstplacetheshoulderstrapsoveryourshouldersandbringtheleg/cheststrap
throughyourlegs.
Fastentheleg/cheststrapwiththeorangebuckles.Ensurethatthebucklesareclosedproperlyand
thatboththeupperandlowerbuttonsclickintoplace.
The automatic pod closing system should now be
connected.Firstattachtheredloopofthelefthandpod
aptotheredballsituatedunderthemaillonontheright
handsideoftheharness.Theredballgoesthroughthe
redloop.
Nextpasstheredloopoftheanti-forgetsystemthrough
theeyeletontherighthandpodnexttotheinstrumentpanel.
Theredballfoundunderthelefthandmaillonshouldnow
bepassedthroughtheloopoftheanti-forgetsystem.
Theshoulderstrapretainerclipshouldnowbefastened.