OZTI OBY 500D - 5.9 Appliance Deactivation and Maintenance

16
5.8.2 Models With a Drain Pump (Optional):
In each operation, drain system is automatically activated when rinsing cycle is started. Once washing cycle is
complete, open the door and remove the drain plug. Remove Drain pipe, Press the ‘Washing Stop’ switch for 3 sec.
when the drain character occure on LCD screen, drainage operation will start automatically. After discharge time
(Factory Settings) finished,the drain pump will stop automatically. After finish the drain process press the’On/Off’
switch for the turn off the machine.
Note: Once draining is complete, it is recommended to disconnect mains water and electrical supply, and clean the
appliance as described. For a more hygienic operation, leave the appliance door open after the draining process to
ensure that boiler is naturally dried.
5.9 Deactivating the Appliance:
If you need to remove or deactivate the appliance for any reason, appropriate local or national regulations should be
observed. Öztiryakiler recommends the following procedures.
 Remove chemical hoses from their drums carefully, then close the container lids to avoid chemical spillage.
Refer to safety notes for the chemical drums to prevent any damage due to spillage.
 Make sure that water is fully drained off the appliance, and then remove the drain hose from the drain vent.
Wipe and dry moist areas of the appliance after draining.
 Turn off the mains power supply.
 If the appliance is plugged to the plug socket, disconnect it.
 If cable terminals are connected directly to the electrical panel, call a qualified electrician to carry out the
disconnection as per local and national wiring regulations.
 After disconnection, make sure that the voltage / ground wire is removed from its housing on the rear part of
the appliance.
 Turn off water supply to the appliance and isolate the water inlet hose. Before proceeding with the next step,
dry out any leak.
 Unscrew the bottom panel and remove it.
 Remove the boiler discharge plug and drain water into a vessel. The vessel should have a 6-litre capacity.