- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲ INSTRUCTION MANUAL
TERAPRESS TP 7500S
Mounting Press
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1-520-882-6598 Fax +1-520-882-6599 email: pace@metallographic.com Web: https://www.metallographic.com
1.0 Safety Guidelines
1.1 Warning Sign
!
This sign points to special safety features on the machine.
1.2 Safety Precautions
1
(Safety Precautions continued on next page)
!
Supplying incorrect voltage will cause severe damage to the electrical system.
Verify the operating voltage listed on the serial plate on back of machine
(indicated in section 3.3).
!
It is recommended that no extension cords or multiple outlet connectors be
used as this may cause the fuse to overheat but not blow during operation.
!
Careful attention to this instruction manual and the recommended safety
guidelines is essential for the safe operation of the TERAPRESS TP 7500S
mounting press.
!
Proper operator training is required for operation of the TERAPRESS TP
7500S mounting press. Unauthorized mechanical and electrical changes, as
well as improper operation, voids all warranty claims. All service issues need
to be reported to the manufacturer / supplier.
!
Caution: DO NOT POSITION HEAD OR OTHER BODY PARTS OVER THE
MOLD WHEN RAISING THE RAM TO REMOVE THE SPECIMEN MOUNT
!
During operation, the closure and upper parts of the heating and cooling block
can get very hot. For safety, do not touch the closure unit. Use protective
gloves if required.
To Next Page