EasyManua.ls Logo

Pacific Crest PDL - APPENDIX C - TECHNICAL SPECIFICATIONS; General Specifications; Radio Specifications; Transmitter Specifications

Pacific Crest PDL
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
PDL/ADL/SDL User's Guide
APPENDIX C - TECHNICAL SPECIFICATIONS
General
Serial Port Interface
RS-232 compatible. 1200 to 38400 baud operation with 1 start, 8 data, optional parity, and one stop bit.
Power Supply
9-16 VDC. PDL Rover quiescent/receive power consumption 0.3W. PDL/ADL/SDL High Power Base
quiescent/receive power consumption is 1.9W. PDL/ADL/SDL Base in the low/high RF power setting
consumes 13W/125W during transmission. The PDL Low Power Base quiescent/receive power
consumption is 0.9W. The PDL Low Power Base when transmitting consumes 5W/11W. (PDL Base
power consumption measured at 12.5 VDC.)
Radio
Frequency Ranges
Contact factory for available frequency ranges. Synthesized frequency control with approximately 1600
channel capability. Channel spacing 25/12.5 kHz. 2.5 ppm frequency reference.
Transmitter (PDL Base)
Carrier power 2-Watts or 35(45/25)-Watts nominal for PDL(ADL/SDL). Carrier power for the Low Power
Base is factory programmable for the 0.5W or 2W. Output impedance 50-ohms. Modulation distortion is
less than 5%. Transmitter attack time < 18 ms. Spurious and harmonic FM -55 dBc. FM hum and
noise -40 dBm.
Receiver
Sensitivity -116 dBm or better (12dB SINAD). Selectivity for the PDL HPB and Rover is >-60 dB.
Selectivity for the PDL LPB is >-70dB. (9600, GMSK, 25 KHz), and >-60 dB (19,200, 4LFSK, 25 KHz).
FM hum and noise -40 dB. Conducted spurious -65 dB. Carrier detect attack time 2 ms.
Modem
Transmission Rate
19,200 or 9,600 bits per second (Four-level FSK)
9,600 or 4,800 bits per second (GMSK)
Transmission Protocols
Transparent, packet switched, auto-repeater, fast asynchronous, Trimtalk™.
Forward Error Correction and Detection
With FEC enabled, data is encoded by a block code. The data is interleaved in blocks of 20 words, giving
burst error correction capabilities for up to 20 consecutive corrupted bits. 16-bit CRCs are generated and
sent with every block of data providing 100% error detection for burst errors shorter than 16 bits, and
99.9984% detection of all other burst errors.
Modulation
Gaussian Minimum Shift Keying (GMSK) with BT of 0.5 (4800, 9600 bps link rate). Four-level FSK
(9600, 19200 bps link rate).

Related product manuals