8 -
Packard Bell DVD DivX 300/350 User's Guide
SETTING UP YOUR DVD PLAYER
Box contents
1. Remote control
2. SCART cable
3. User’s Guide & Service Guide
4. Batteries
Inserting remote control batteries
Open the lid of the battery compartment and install 2 AAA batteries. Assure correct placement.
Connections
1. Before connecting, make sure to turn off the power of each apparatus.
2. After finishing connection, turn on the power again.
The AV cable (optional) is colour coded.
Yellow plug -------- video terminal (yellow)
White plug --------- left audio terminal (white)
Red plug ----------- right audio terminal (red)
Please make sure that colours of connectors and plugs correspond.
DVD player and TV set
Depending on the connectors that are available on your TV set, you may need an additional cable. Please
check your TVs documentation for the best possible connection.
You may need to use the Video Out and Progressive Scan buttons to set the video output mode correctly.
Please check the table below.
OUTPUT PORT VIDEO SCANNING MODE VIDEO OUTPUT MODE
VIDEO
Interleaved CVBS, CVBS+YUV,
CVBS+S-VIDEO
S-VIDEO Interleaved CVBS+S-VIDEO
SCART Interleaved RGB
Y/Cb/Cr Interleaved CVBS+YUV
Y/Pb/Pr Progressive scan PSCAN
DVD DivX 350 6940100200.book Page 8 Wednesday, May 25, 2005 2:18 PM
To Next Page