EQUIPMENT DESCRIPTION
T6M SERIES MOBILE SERVICE MANUAL – SM/16/1.0Page 3-2
3.1 General
The T6M series mobile radio is designed to operate in single frequency
simplex mode on the International Air Band allocation (118-137 MHz mobile
transmit and receive).
The mobile radio is field programmable, allowing it to be customized both for
the frequency allocation for which it is intended, and for the particular user.
Refer to the built in help facilities of the Mobile Programming Software for
more information.
The mobile radio is designed to be mounted in the driver’s compartment of a
road vehicle. It can withstand the vibration, shock and extremes of
temperature typically encountered in this environment. The mobile radio’s
basic construction consists of a die-cast alloy chassis, and an injection
molded ABS front panel.
3.2 T6M Series Mobile Front panel
3.3 Mobile Radio Programming
As well as the standard accessories supplied with the mobile radio (listed in
the installation section of this manual), the following additional accessories
can be used:
3.3.1 Programming Interface Lead
For programming purposes the microphone connector on the mobile radio is
connected directly to the serial port of a PC using a special programming
interface lead.
3.3.2 Programming Software
The personality of the mobile radio must be programmed before it can be
put into service in a system. This is normally done at the time of
manufacture or by the equipment supplier. Special programming software is
To Next Page
Loading...
Need help?
General