Paingone Easy - Troubleshooting and Disposal; Troubleshooting Guide; Storage Guidelines; Product Disposal

65
The electrode pads can be washed to restore adhesiveness.
Remove the pad from the device before washing. Allow to dry
thoroughly before re-attaching to the control unit.
The control unit does not require maintenance or calibration. Do
not attempt to open the control unit for any reason. If a fault is
suspected, contact the point of purchase.
Please remove the batteries if the stimulator is not to be used for a
long time.
Storage
1) Please keep the stimulator out of reach of children
2) Do not store the device in places where it will be exposed to
direct sunlight, high temperature or moisture.
3) Please store the device in a dry and ventilated space
2. Product disposal
In order to avoid environmental pollution, please dispose this
Device according to local environmental requirements. Do not
discard in your standard waste disposal.
Troubleshooting
There is no
output (electrical
pulses) or the
output feels low
The battery is
running low or
running out
The electrode
pad is damaged
or dirty, has no
stickiness or is
making poor
contact with the
skin
Skin is too oily
The device is
damaged
Replace the
battery
Replace with a
new electrode
pad
Wipe skin with a
wet towel or
alcohol Allow to
dry fully before
using the device
Contact the point
of purchase
The device does
not power up
correctly
The battery is
installed
incorrectly
The battery is
running low or
running out
The button is
damaged
Use CR2032
button batteries.
Please install the
battery properly
with the “+” pole
facing upwards
and the “-” pole
facing
downwards
Replace the
battery
Contact the point
of purchase
The device does
not emit any
"beep" sound
The speaker is
damaged
Contact the point
of purchase
The buttons are
not functioning
correctly
The battery is
running low or
running out
The button is
damaged
Replace the
battery
Contact the point
of purchase
Problem Analysis of cause Recommended
Solution
The skin is
strongly
irritated/shows
signs of redness
The treatment has
been applied too
long
The intensity is set
too high
The electrode
pad is not making
good contact
with the skin
There may be an
allergic reaction
to the electrode
pad
The electrode
pad is dirty
Limit treatments to
15 minutes
Decrease the
intensity to a more
comfortable level
Press the
electrode pad
firmly against the
skin to improve
contact
Cease use of the
device
Clean the
electrode pad