2
power on the 4 PSE ports for connected devices via
CAT 5 or above twisted cables. By integrating the data
transmitting cable and power cord, it eliminates the
effort constructing your network. You can easily connect
a Wireless AP or a VoIP phone (PD devices) to this
switch without installing outlets for them. Over current
protection and circuit shorting protection are also
supported to ensure the safety.
The switch is plug-n-play without any software to
configure and also fully compliant with all kinds of
network protocols. Moreover, the rich diagnostic LED
indicators on the front-panel provide the operating
status of individual port and whole system.
Key Features
Provide 8x 10/100Mbps auto-detect half/full and
1000Mbs full duplex switch ports (IEEE802.3/
802.3u/ 802.3ab)
Supports MDI/MDI-X auto crossover
Supports one port PD power input complying with
high-power PD (IEEE802.3at) and an optional DC
power input in 48V (Power Adaptor).
Provides 4 PSE ports complying with IEEE802.3af
with classification identify
Supports over current protection and circuit
shorting protection
Supports up to 8K MAC address table
Supports maximum 9216 bytes jumbo packet
length forwarding at wire speed
To Next Page
Loading...
Need help?
General
