Need help?Do you have a question about the Pakedge Device & Software SE-8P4 and is the answer not in the manual?
General| Power over Ethernet (PoE) | Yes |
|---|---|
| PoE Ports | 4 |
| PoE Budget | 60W |
| PoE Standard | IEEE 802.3af |
| PoE Power per Port | 15.4W |
| Switching Capacity | 16 Gbps |
| Forwarding Rate | 11.9 Mpps |
| MAC Address Table | 8K |
| Jumbo Frame Support | 9KB |
| Power Input | 100-240V AC, 50/60 Hz |
| Humidity | 10% to 90% non-condensing |
| Ports | 8 |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -4 to 158°F / -20 to 70°C |
Details compliance with EMC, Low Voltage, and RoHS directives.
Provides an overview of the SE-8P4 switch, its ports, architecture, and PoE capabilities.
Highlights the switch's compliance with IEEE standards and advanced networking functionalities.
Details System and Port LEDs, including Power, Loop, Link/ACT, and PoE indicators for diagnostics.
Steps for placing the switch on a desktop, including attaching feet and connecting power.
Details auto-negotiation for port speeds (10/100/1000Mbps) and duplex modes.
To Next Page
