2
WAP-C3N INSTALLATION QUICK GUIDE
2. To open cover, first slide the latch outward to disengage the
tab and second, push in the cover on the red dot (outer edge
of cover, directly opposite of the latch).
3. Use a Phillips screw
driver to engage the mounting-ears as shown in a
clockwise rotation until the screws are difficult to rotate.
NOTE: Do not over-tighten the mounting-ears as excessive
torque will strip the mounting-ears and render them non-
functional.
4. Connect the cat5e/6 cable to the Power-
over-Ethernet port (PWR+LAN IN) of the
WAP-C3G and route the cable as shown.
NOTE: If the cable is not routed in this
fashion, the cable could be damaged and the
unit may not function properly.
Push
Here
To Next Page
Loading...
