Need help?Do you have a question about the Pakedge Device & Software wap-c3n and is the answer not in the manual?
General| Brand | Pakedge Device & Software |
|---|---|
| Model | wap-c3n |
| Category | Wireless Access Point |
| Language | English |
Sets the device to operate as a wireless access point.
Specifies the IP address for accessing the access point, defaulting to 192.168.1.250.
Default login credentials for the access point are 'pakedge' and 'pakedgea'.
The default network name (SSID) for the wireless network is 'Pakedge1'.
Configures the wireless signal power output to 'High'.
The default security setting for the wireless network is 'Disabled'.
Locate an in-ceiling/wall position and use the template to trace and cut a mounting hole.
Instructions on how to open the device cover by disengaging a latch and pushing a specific point.
Using a Phillips screwdriver to rotate mounting ears until difficult to turn, avoiding over-tightening.
Connects the cat5e/6 cable to the Power-over-Ethernet port (PWR+LAN IN).
Plugs the Ethernet cable into a PoE injector or PoE Switch for power and data.
Guides users to configure PC's TCP/IP settings to match the WAP's IP address for login.
Instructs to set a static IP address and subnet mask on the PC for network communication.
Steps to close the IP address configuration windows after making changes.
Details on how to access the WAP's configuration screen by entering its IP address in a web browser.
Shows how the WAP status page appears, displaying system and network information.
To Next Page
