pg. 27
WK-1x User Guide
LAN
• IP Network Setting: Static addresses require an IP Address, Subnet Mask, and Default
Gateway. Static address is the recommended setting. However, you may select DHCP client if
your network has a router.
Management VLAN
Warning: Do not enable this feature unless you need to tag the default VLAN on the access
point. If configured incorrectly, the access point will become inaccessible and will need to be reset to
factory default. VLAN tagging can only be set on a managed switch capable of using VLANs.
• VLAN ID for Management: To turn on VLAN Management, check Enable under Management
VLAN.
• In the VLAN ID text box, enter the number of the VLAN you want to access the administrative
functions of the WK-1x through. For example, if VLAN3 is used for management, type in 3.
• Click Apply to save your changes.
To Next Page
Loading...
