What to do if PAL Swimming Pool Lighting driver is not connected or switched on?
If your PAL Swimming Pool Lighting is not turning on, first verify that the driver is properly connected to a power source and switched on. Check if the power indicator LED on the driver is lit. If the LED is still not lit, return the product to PAL for repair.
Why is my PAL EVEN GLOW not turning on?
If your PAL Swimming Pool Lighting is not turning on, it might be due to a faulty driver. Check the driver output under load using a multimeter; it should be 12 volts DC.
How to fix PAL EVEN GLOW Swimming Pool Lighting when lights are out of sync?
If your PAL Swimming Pool Lighting is out of sync, the light may be incorrectly wired to the control box. Check the color wire sequences connecting to the control box.
What to do if PAL Swimming Pool Lighting is not turning on because of a cut cable?
If your PAL Swimming Pool Lighting is not turning on, a cut cable may be the cause. Use a multimeter to check the voltage at the light.
What to do if PAL EVEN GLOW is not turning on due to a faulty LED driver inside the control box?
If your PAL Swimming Pool Lighting isn't turning on, and you suspect a faulty LED driver inside the control box, push the test button inside the control box. If the lights still don’t turn on, send the product back to PAL.
What to do if PAL EVEN GLOW is out of sync because of incorrectly wired lights?
If your PAL Swimming Pool Lighting is out of sync, the lights may be incorrectly wired to the LED lamp. Check the color sequences to the LED lamp terminal block inside the light.
Key details on electrical code compliance, required certifications, and driver specifications for 12V underwater lights.
Requirements for 1.5" wall fitting installation according to Canadian Electrical Code and local ordinances.
Step-by-step instructions for pulling the cable and assembling components for fibreglass light installation.
Guidance on applying silicone and tightening the light fixture to ensure a watertight seal.
Instructions on how to twist the light clockwise to install and anti-clockwise to remove from the fitting.
Diagram showing the final assembly of the PAL Even glow Fibreglass Light with conduit adapter.
Procedure for connecting the light fixture, including unscrewing protective caps and securing the screw-on cap.
Details on powering the PAL-EGF light with PAL PCR-4 or PCR-2D drivers and PCT-1 transmitter.
Instructions for setting DIP switches to clone PAL lights with Jandy, Pentair, or Hayward systems.
Identifies common issues like lights not turning on or being out of sync, with reasons and actions.
Details the 12-month PAL product warranty, conditions for invalidation, and liability limitations.
The provided document is an installation manual for the PAL EvenGlow Wet Niche LED light, designed for use in fiberglass and vinyl pools. This manual covers installation, connection, troubleshooting, and warranty information for the product.
The PAL EvenGlow is a 12V LED underwater light designed for wet niche installation in swimming pools. It provides illumination for the pool and is part of the PAL Lighting system, which includes a compatible LED driver and a wireless transmitter for color control. The light is specifically designed for use with the PCR-4 and PCR-2D UL Listed Class 2 LED Drivers, ensuring safe low-voltage operation. It is crucial not to connect this 12V light directly to a 120V circuit. The system supports various cloning features, allowing it to synchronize with other OEM lights like Jandy, Pentair, and Hayward, although color change mode timing may vary in such cases. The PAL Color Touch Driver system offers color selection and dimmability features, though these advanced features are not available when the light is operating in cloned mode.
General| Brand | PAL |
|---|---|
| Model | EVEN GLOW |
| Category | Swimming Pool Lighting |
| Language | English |
To Next Page
