To Next PageTo Next Page
Need help?Do you have a question about the Panamax MB1500 and is the answer not in the manual?
General| Power Rating | 1500 VA |
|---|---|
| Output Power | 900 W |
| Input Voltage | 120 V |
| Output Voltage | 120 V |
| Form Factor | Tower |
| Number of Outlets | 8 |
| Outlets | 8 NEMA 5-15R |
| Battery Backup | Yes |
| Transfer Time | 4 ms |
| Waveform Type | Simulated Sine Wave |
| Typical Recharge Time | 8 hours |
| Relative Humidity | 0-95% non-condensing |
| Battery Type | Sealed Lead Acid |
| Input Voltage Range | 90-140V |
| Frequency Range | 50/60Hz |
| Operating Temperature | 32 to 104°F (0 to 40°C) |
| Storage Temperature | -15 °C to 45 °C |
| Audible Noise | Less than 45 dBA |
| Protection | Surge |
Monitors AC line voltage for unsafe conditions and disconnects equipment.
Disconnects equipment if surge exceeds protection capacity.
Provides linear AC noise filtering for optimal performance.
Regulates input voltage to provide a stable output within specified ranges.
Unit switches to battery power during power loss or voltage faults.
Sets threshold to reserve battery power for critical load outlets.
Allows programming the unit to send IR commands for equipment shutdown.
Details RS-232 interface usage, commands, and connector pin-out.
Format for responses indicating power fault conditions.
Displays the remaining runtime the battery backup can supply.
Icons indicating power lost, under/over voltage, voltage boost/buck, or normal.
Estimates minutes of battery runtime until shutdown.
Configure schedules for automatic computer shutdown and restarts.
Configure preferred runtime settings for battery backup.
Tests battery backup functionality and displays results.
Choose between 'Keep Computer Running' and 'Preserve Battery Power'.
Initiate and understand the results of the battery backup self-test.
