Panasonic 2 Line KX-TG9541C - Page 10

If you subscribe to a DSL/ADSL
service
Please attach a DSL/ADSL filter (contact your DSL/
ADSL provider) to the telephone line between the
base unit and the telephone line jack in the event
of the following:
– noise is heard during conversations.
– Call Display features do not function properly.
To connect to a 2-line telephone jack
For this connection, please purchase a 2-line
splitter.
Example: DSL/ADSL line is line 2
Connect the “Transparent” plug telephone line
cord (2-wire cord) (
1
) to the 2-line splitter
(
3
) until you hear a click.
Connect the “GREEN” plug telephone line
cord (4-wire cord) (
2
) to a DSL/ADSL filter
(not supplied) (
4
), then to the 2-line splitter
(
3
) until you hear a click.
Connect the 2-line splitter (
3
) to the 2-line
telephone jack (RJ14C) (
5
) until you hear a
click.
12
5
4
2
13
“GREEN”
plug
“Transparent”
plug
*DSL/ADSL filter (not supplied) is required if you
have DSL/ADSL service.
To connect to 2 single-line telephone jacks
Example: DSL/ADSL line is line 2
Connect the “Transparent” plug telephone line
cord (2-wire cord) (
1
) to the unit, then to the
single-line telephone jack (RJ11C) (
2
) until
you hear a click.
Connect the “GREEN” plug telephone line
cord (4-wire cord) (
3
) to a DSL/ADSL filter
(not supplied) (
4
), then to the single-line
telephone jack (RJ11C) (
5
) until you hear a
click.
12
2
5
4
3
1
“Transparent” plug
“GREEN”
plug
*DSL/ADSL filter (not supplied) is required if you
have DSL/ADSL service.
Battery installation
R USE ONLY Ni-MH batteries AAA (R03) size
(A).
R Do NOT use Alkaline/Manganese/Ni-Cd
batteries.
R Confirm correct polarities (
, ).
1
R Follow the directions on the display to set up
the unit.
Battery charging
Charge for about 7 hours.
R Confirm “Charging” is displayed (A).
10
Getting Started
TG9541C(en)_0723_ver012.pdf 10 2013/07/23 12:24:51