Panasonic 96NKX-UT248

Setting Description Value Range Default
Network Configure the basic network settings.
If you select "DHCP", you must then
select whether the DNS setting is
configured automatically or
manually. If you select "STATIC",
you must manually specify the IP
address, subnet mask, default
gateway, and DNS servers.
DHCP, STATIC —
When DHCP is selected
DNS Select whether the DNS server
information should be obtained
automatically (i.e., provided by the
DHCP server) or if you will specify it
manually.
If you select "Manual", see "DNS1"
and "DNS2" below.
Manual, Automatic Automatic
DNS1
*1
(Manual DNS
only)
Enter the IP address of the primary
DNS server.
xxx.xxx.xxx.xxx —
DNS2
*1
(Manual DNS
only)
Enter the IP address of the
secondary DNS server.
If a secondary DNS server is not
required, leave this item blank.
xxx.xxx.xxx.xxx —
When STATIC is selected
IP Address
*1
Enter the IP address to assign to the
unit.
xxx.xxx.xxx.xxx —
Subnet mask
*1
Enter the subnet mask for your
network.
xxx.xxx.xxx.xxx —
Default Gateway
*1
Enter the IP address of the default
gateway for your network.
xxx.xxx.xxx.xxx —
DNS1
*1
Enter the IP address of the primary
DNS server.
xxx.xxx.xxx.xxx —
DNS2
*1
Enter the IP address of the
secondary DNS server.
If a secondary DNS server is not
required, leave this item blank.
xxx.xxx.xxx.xxx —
VLAN Configure the VLAN (Virtual LAN)
settings.
— —
Enable VLAN Select whether to enable the VLAN
functionality.
Yes, No No
IP Phone Specify the necessary settings for
using the phone features over a
VLAN.
— —
44 Operating Instructions Document Version 2011-10
Customizing the Telephone