Notice in operation:
6.5 Disassemble BARRIER PF AS.
6.6 Disassemble COVER DUMPER PC AS.
front side back side
Air
SEAL DUCT
SEAL DUCT layer on the back side of COVER DUCT PC As. has 1 sticky side. Avoid
deforming SEAL DUCT in operation. Air guide installation will be stucked if SEAL DUCT is
① Take out all the upper and
bottom tray of BARRIER PF
AS.
② Take out 4 screw above and
at the bottom as in the picture.
③ Pull out BARRIER PF AS by
two hands at once as show in the
fingure. .
screw position
BARRIER PF AS. front side and back side
① Position of COVER
DUMPER PC AS.
screw position
②
Remove 2 screws
③ Undo 2 connectors of
SENSOR PFC and PCC then
take COVER DUMPER PC AS.
To Next Page
Loading...
