Panasonic A Series - Cover Board, PCB, Supply Cord, and Motor Protector

6.11 Tháo COVER BOARD, PAS-CONTROL PCB (INV)
, SUPPLY CORD và CASE BOARD
6.12 Take out MOTOR PROTECTOR
⑥ Cut the tube bending of
TEMP. FUSE then take TEMP.
FUSE out.
TEMP. FUSE
①Unscrew 02 screws
star screw
② Take COVER BOARD out
③ Remove 3 screws and undo
connector to take out SUPPLY
CORD AS. as in picture
screw
Connector
④ Take 5 remained connector on
the circuit, press to the 2 hooks
to take the circuit out.
PAS
-
CONTROL PCB (INV)
⑤ Remove 4 screws and split electric wire apart to take out CASE
BOARD
screw
① Take out PAN WATER
EVA
② Take COVER PROTECTOR
out
③ Pull MOTOR PROTECTOR
out
MOTOR
PROCTECTOR
13