Chapter 4 Operation — Menu settings
- 71 -
[CH2 LIMITER]
Switches enable/disable of the limiter when the method to adjust the audio input level for audio channel 2 is manual.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
0 In the following case, [CH2 LIMITER] is fixed to [ON]:
j When [CH2 LEVEL] is set to [AUTO]
j When the <CH2> switch is set to <AUTO>
[MIC LIMITER LINK]
Sets whether to make the limiter work on the other audio channel when the limiter works in either audio channel 1 or audio channel 2.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
0 In the following case, [MIC LIMITER LINK] is fixed to [OFF]:
j [CH1 LIMITER] or [CH2 LIMITER] is set to [OFF]
[OUTPUT SETTINGS]
[AUDIO OUT]
Sets the audio channel and the format to output from the headphone terminal, and the built-in speaker.
(Factory setting: [CH1/2 STEREO])
[ALARM]
Sets whether to have an alarm sound.
The alarm is output from the speaker of this unit or the headphones. It is not output to external output destinations.
[BATTERY END]
Sets whether to sound the alarm when the remaining battery level is exhausted.
The items that can be set are as follows.
≥ [HIGH], [LOW], [OFF]
(Factory setting: [OFF])
[MEDIA END]
Sets whether to sound the alarm when the remaining recording capacity of the memory card is exhausted.
The items that can be set are as follows.
≥ [HIGH], [LOW], [OFF]
(Factory setting: [OFF])
[WARNING]
Sets whether to sound the alarm when a system error or warning occurs.
The items that can be set are as follows.
≥ [HIGH], [LOW], [OFF]
(Factory setting: [OFF])
[VIDEO OUT/LCD/VF] menu
Configures the settings for the external output, the information to display in the LCD monitor or viewfinder and the output format.
/
[VIDEO OUT SEL]
Switches the output destination for images and audio.
(Factory setting: [HDMI])
[CH1] Outputs the signal for audio channel 1 as monaural.
[CH2] Outputs the signal for audio channel 2 as monaural.
[CH1/2 STEREO] Outputs the signals of the audio channel 1 and the audio channel 2 as stereo. Outputs as monaural from the built-in speaker.
[CH1/2 MIX] Mixes the signals of the audio channel 1 and the audio channel 2 and outputs as monaural.
[SDI] Outputs from the <SDI OUT> terminal.
[HDMI] Outputs from the <HDMI> terminal.
To Next Page
Loading...
