Chapter 4 Operation — Menu settings
- 79 -
[ZEBRA2]
Switches enable/disable of zebra pattern 2.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
[WFM MODE]
Sets the display of the waveform monitor. Displaying of the waveform and the vector can be switched.
(Factory setting: [WAVE])
[WFM TRANSPARENCE]
Sets the transmittance of the waveform monitor.
The items that can be set are as follows.
≥ [0%], [25%], [50%]
(Factory setting: [25%])
[LEVEL GAUGE]
[LEVEL GAUGE]
Switches display/hide of the level gauge.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [ON])
[LEVEL GAUGE RESET]
Sets the horizontal and vertical reference value set by [LEVEL GAUGE SET] in the USER button to the factory setting.
The items that can be selected are as follows.
≥ [YES], [NO]
[RECORDING] menu
Sets the various items in the recording function.
[FORMAT MEDIA]
Formats the memory card in the specified card slot.
All data will be deleted when the card is formatted. Save any important data to a computer, etc. (l 171)
The items that can be selected are as follows.
≥ [SLOT1], [SLOT2]
[CLIP NAME]
[CAM INDEX]
Sets the CAM INDEX used for recorded MOV format/MP4 format file names.
Set one upper case alphabetical character. This is used as a value to be stored in the volume label of the memory card.
The items that can be set are as follows.
≥ [A]…[Z]
(Factory setting: [A])
[NEXT CARD COUNT]
Sets the CARD COUNT used for recorded MOV format/MP4 format file names.
In the following cases, the setting value in [NEXT CARD COUNT] is stored in the volume label of the memory card together with the [CAM INDEX] setting
value as CARD COUNT. Also, the setting value will increase one after storing. ([001] returns after [999])
≥ When formatted the memory card
≥ When recorded to the memory card where CARD COUNT is not stored in the volume label
The items that can be set are as follows.
≥ [001]…[999]
(Factory setting: [001])
[WAVE] Displays the waveform.
[VECTOR] Displays the vector.
[WAVE/VECTOR] Displays the waveform and the vector.
Each time you either press the USER button assigned to [WFM] or touch the USER button icon, the display switches in the
order waveform, vector, no display.
To Next Page