Panasonic AG-HMC150 - Media, Battery, and Workflow; SDHC Cards, Recording Modes, and Battery

11
IMPORTANT - THE SOUND CART SHOULD COME PRE-WIRED. IN THE EVENT IT IS NOT
PLEASE FOLLOW THE FOLLOWING INSTRUCTIONS.
SOUND DEVICES MIX PRE AUDIO MIXER & TASCAM DR-40 RECORDER SETUP
Sound Devices Mixer Left Side – Input Panel
1. Plug microphone XLR plug into Mic Input 1
2.
• Set Phantom to 48v (up)
• Set Lowcut to 80 (up)
• Set Limiter to ON (down)
Sound Devices Mixer Right Side – Output Panel
3. Plug the XLR-F

¼” TRS cable into Line Output 1
(other side connects to Tascam Recorder Line In – See Next Step)
Tascam Recorder
4. Plug the ¼” TRS  XLR-F cable into Line In on Recorder
(other side connects to Sound Devices Mixer Line Output – See Previous Step)
48v 80 ON