Put the SD Chip into the bay/slot at the rear of the camera
The SD Chip bay/slot is located at
the rear of the camera.
Open, by pushing the door to the
le, then gently pulling down on
the door.
Push your card into the slot, then
close the door, in the reverse order
that you opened the door.
Turn on the camera.
NOTE
Do not open the card door when the camera is on.
If you need to swap cards:
1. Stop recording.
2. Turn o the camera.
3. Swap cards.
To remove/swap the card:
1. turn o the camera.
2. Open the card door.
3. Push lightly on the card to ‘pop’ it out.
4. Remove the card by gently pulling on the piece now scking out.
Camera O Posion. Camera On Posion.