Operation
Before proceeding to operate the unit, make sure that the unit has been connected properly.
1
Turn on the unit’s power.
2
Insert the cassette tape.
Insert it at the prescribed position without forcing it in any way.
3
Check that the STOP lamp is lighted.
When the tape is inserted, the cylinder starts rotating automatically, the tape is loaded,
and the STOP mode is established.
<Note>
It is possible to change the mode when a tape is inserted using the settings in Item No.
104 “TAPE IN MOD” of the Setup menu. (See page 29)
Turning on the power/inserting a cassette
1 2
3
To Next Page
Loading...
