Panasonic AJ-D250P - Setting the Time Code; Setting the Users Bit

19
Setting the time code
Now follow the same procedure as for setting the time code.
1
Set the unit to the menu mode (by setting the LOCAL/MENU/REMOTE switch to the
MENU position).
<Notes>
O
The current time code value appears as the default value.
O
When the RESET button is pressed while the digit to be changed is blinking, the display is
reset to “00:00:00:00.”
O
The time code cannot be set unless P-REC or P-FREE has been selected as the “TC MODE”
setup menu item setting. (See page 32)
O
If the MODE button (REW button) is pressed instead of the SET button while the digit to be
changed is blinking, the time code setting will be canceled.
2
Select the “TC PRESET” setup menu item, and press the DATA+ button
(PAUSE/STILL button) or DATA– button (PLAY button).
(See page 32)
3
Select the digit to be changed (blinking display) using the UP button (FF button) or
DOWN button (STOP button).
4
The value is incremented or decremented using the DATA+ button (PAUSE/STILL
button) or DATA– button (PLAY button).
5
Press the SET button (REC button) upon completion of the settings.
Setting the user’s bit
1
Set the unit to the menu mode (by setting the LOCAL/MENU/REMOTE switch to the
MENU position).
2
Select the UB PRESET setup menu item, and press the DATA+ button
(PAUSE/STILL button) or DATA– button (PLAY button).
(See page 32)
Time Codes and User’s Bit
6
Set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position.