12
1
When the STOP button is pressed, the STOP mode is established.
The STOP lamp lights, and the tape stops traveling.
O
In order to protect the tape, the tape protection mode will be established when the time
selected for the “STILL TIMER” setup menu item setting has elapsed. (See page 31)
When the STOP, REW, FF or PLAY button is pressed, the corresponding mode will be
established.
<Checkpoint for STILL TIMER setting>
O
Repeatedly using the same locations on the same tape will increase the cumulative standby
time at those locations. In the interest of protecting the tape, keep the standby times at the
same locations as short as possible.
STOP mode
To Next Page
Loading...
