UNDERSTANDING PANASONIC AJ-HDC27H
© ALLEN YEUNG 2008
7 / 12
UG_AJ-HDC27H_v1.doc
OPERATION
1
Adjusting Frame Rate (P.61)
1. Locate current frame rate on the screen (Top left corner)
2. Press JOG DIAL (Frame rate blinking)
3. Press “+” or “-“ (2@P.14) to adjust frame rate
Activate Frame Rate under 11FPS (P. 106)
MAIN MENU 2 => FRAME MODE => FRAME RATE RANGE => 60-4
Adjusting Shutter Angle (P.57)
1. Locate current shutter angle on the screen (e.g. SS: 180.0 deg)
2. Tap down SHUTTER switch(7@P.16) until “SS:◆180.0deg” is appeared
3. Press “+” or “-“ (2@P.14) to adjust shutter angle
Manual White Balance (P. 53)
1. Turn CC Filter(1@P.14) to closet existing colour temperature
2. Fill up the screen with a white paper
3. Adjust aperture to prevent over of under exposure
4. Select A or B switch(3@P.14)
5. Tap up AWB switch(6@P.15)
6. Wait until “AWB OK” is appeared
*If NG is display, re-adjust CC Filter or aperture
Setting White Balance Preset (P. 99)
MAIN MENU 1 => CAMERA SETTING => LIGHTING
Manual Black Balance (P. 56, Important!)
1. Close Aperture
2. Tap down ABB switch(6@P.15)
3. Wait until “ABB OK” is appeared
Gain Control (P. 56)
Setting Gain for Gain Switch(5@P. 15) (P. 96)
MAIN MENU 1 => LOW SETTING => MASTER GAIN
* Require Black Balance Reset
To Next Page
Loading...
