EasyManua.ls Logo

Panasonic AJ-VF15BP

Panasonic AJ-VF15BP
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-2
2. Electrical Adjustment Procedure
(AJ-VF15)
2-1. Power voltage Adjustment
BOARD MAIN BOARD
SPEC 9.5V +/- 0.1V
TEST TP2 (CN3 Connector 1pin)
ADJUST RV1 [V0-ADJ]
M.EQ Digital Volt Meter
1. Adjust RV1 so that the Voltage at TP2 is 9.5V+/-0.1V.
2-2. V Free Run Adjustment
BOARD MAIN BOARD / SUB1 BOARD
SPEC 48Hz+/- 0.5Hz (NTSC)
38Hz+/- 0.5Hz (PAL)
TEST TP12 (CN2 Connector 4pin)
/MAIN BOARD
ADJUST RV2 [V-HOLD] / SUB1 BOARD
M.EQ Frequency Counter
1. Adjust RV2 so that the frequency at TP12 is 48Hz+/-
0.5Hz (NTSC) / 38Hz+/- 0.5Hz (PAL)
2-3. H Free Run Adjustment
BOARD MAIN BOARD / SUB1 BOARD
SPEC 15.73+/-0.05kHz (NTSC)
15.63+/-0.05kHz (PAL)
TEST TP9 (CN2 Connector 1pin)
/MAIN BOARD
ADJUST RV1 [H-HOLD] /SUB1 BOARD
M.EQ Frequency Counter
1. Adjust RV1 so that the frequency at TP9 is 48Hz+/-
0.5Hz (NTSC) / 38Hz+/-0.5Hz (PAL).
2-4. Focus Adjustment
BOARD MAIN BOARD
SPEC 5.8kV +/- 0.1kV
TEST High Voltage Connector (FBT Side)
ADJUST RV5 [FOCUS]
M.EQ Digital Volt meter
[Use High voltage prove]
1. Set the CONTRAST VR, BRIGHT VR to the center and
PEAKING VR to the minimum position.
2. Connect the high voltage voltmeter with the high voltage
prove to the connector between the FBT and anode cap.
3. Adjust RV5 so that the High Voltage is within
specification.
2-5. Screen size Adjustment
BOARD MAIN BOARD / SUB1 BOARD
TEST EVF Picture
ADJUST RV3 [H-SIZE (WIDE)] / MAIN BOARD
RV3 [V-SIZE] / SUB1 BOARD
RV5 [V-SIZE (WIDE)] / SUB1 BOARD
Adjustment for 4 : 3 mode
1. Open the on-screen menu on the camera recorder in the
3:4 mode so that the EVF screen is 4:3.
2. Adjust RV3 (On SUB1 BOARD) so that the V-BLK as is
within 1.5point scale shown in figure 2.
3. Adjust the RV3 (On MAIN BOARD) so that the circle of
chart is most round.
Note : This adjustment should be performed after com-
pletion the Size Adjustment in the 4:3 mode.
Adjustment for 16:9 mode
1. Open the on-screen menu on the camera recorder in
the16:9 mode so that the EVF screen is 16:9.
2. Adjust RV5 (On SUB1 BOARD) so that the circle of
chart is most round.
Fig.1 Registration Chart

Related product manuals