201
Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Appendix
8
Remote Controller buttons and display
Display
1 Mode selection
*
1,
*
2
AUTO
•Depending on the preset outdoor
temperature, the system selects
HEAT or *
1,
*
2
COOL operation
mode�
Auto Heat Auto Cool
*
1,
*
2
COOL •COOL operation is either turned
ON or OFF�
•The outdoor unit provides cooling
to the system�
*
1,
*
2
AUTO
+ TANK
•Depending on the preset outdoor
temperature, the system selects
HEAT + TANK or *
1,
*
2
COOL +
TANK operation mode�
Auto Heat Auto Cool
*
1,
*
2
COOL
+ TANK
•The outdoor unit provides cooling
to the system�
•The outdoor unit provides heating
when boiling tank�
HEAT
•HEAT operation is either turned
ON or OFF�
•The outdoor unit provides heat to
the system�
TANK
•TANK operation is either turned
ON or OFF�
•The outdoor unit provides heat to
the water tank�
HEAT
+ TANK
•The outdoor unit provides heat to
the water tank and the system�
•This mode can be selected only
when the water tank is installed�
* The direction icons point to the currently
active mode�
•Room operation / Tank operation�
•Deice operation�
2
Operation icons
The status of operation is displayed�
Icon will not display (under operation OFF screen) whenever operation is OFF except weekly timer�
Holiday operation status Weekly Timer operation status Quiet operation status
Zone: Room Thermostat
→Internal sensor status
Powerful operation status
Demand Control or
SG ready or SHP status
Room Heater status Tank Heater status Solar status
Bivalent status
(Boiler)
*
1
The system is locked to operate without COOL mode� It can be unlocked only by authorised installers or our authorised service partners�
*
2
Only displayed when COOL mode is unlocked (This means when COOL mode is available)�
2 43
1
5
6
7
To Next Page
Loading...
