★ By using AW-RP50 controller, you can switch the remote camera’s power supply from STANDBY mode (Power OFF)
to POWER ON mode (Power ON), and vice versa.
* Before you use AW-RP50 controller to control the remote camera’s power supply, you need to set up the connection
with the camera in advance.
For the connection setting-up procedure, please refer to the following Manual 【Controlling AW-HE40 Camera via
AW-RP50 Controller】.
https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/1_.pdf
<Note>
・ Be careful with the Power ON/OFF operation described in this Manual because it can affect the camera’s pan-tilt
head position at the time of turning the power on. (POWER ON Preset Function)
For details, please refer to the following Manual 【Booting Up with Pan-Tilt Head in Specified Position】.
https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/7_.pdf
■ Turning ON/OFF Remote Cameras One by One
＊ For switching the power supply mode of the remote camera (AW-HE40) which is assigned to [CAM1];
1．Keep holding down LED button 1 at CAMERA STATUS/SELECTION area – (Fig.1-A). The selected camera’s name
will be displayed on the upper half, and its power status (POWER ON/POWER OFF) on the lower half of the LCD
panel – (Fig.2).
2．While the LED button 1 is held down at CAMERA STATUS/SELECTION area, turn F2 dial – (Fig.1-B);
(If you turn ON the camera,)
Select “ON” – (Fig.2), and then press the F2 dial. The camera will switch over to POWER ON mode (Power ON).
(If you turn OFF the camera,)
Select “OFF” – (Fig.2), and then press the F2 dial. The camera will switch over to STANDBY mode (Power OFF).
To Next Page
Need help?
General
Weight and Dimensions
