Panasonic Barcode Scanners - First-time Operation and Driver Installation

3
ENGLISH
First-time Operation
After finishing the”First-time Operation” of Operating Instructions, install the driver
for Barcode Scanner using the following procedure.
Install the driver for Barcode Scanner
If the [PanaBCI] file is not inside the [Options] folder in [My Computer], perform all steps
from (1) to (7).
If the [PanaBCI] file is present, perform steps (4) through (7).
(1)Tap [Start]-[Run] in order, then input “ffrestore.exe r”, and then tap [OK].
The driver for Barcode Scanner will be copied from the Flash memory to the [Options]
folder in [My Computer].
(2)When [Complete] is displayed, press
* or * .
* Varies depending on the models.
(3)Double-tap [My Computer], and then double-tap the [Options] folder.
(4)Double-tap [PanaBCI].
A screen will be displayed specifying the install destination folder.
(5)Tap [OK].
(6)When [Setup Complete] is displayed, tap [OK].
(7)Push the reset switch using the stylus.
NOTE
Once the power switch has been pressed, you must wait at least 10 seconds before press-
ing it again.