•
If Security Warning window is displayed to install ActiveX
®
Controls,
click [Yes].
•••
Insert the Setup CD-ROM into the CD-ROM drive of
the PC.
(If the Network Camera Setup window is not displayed automatically,
double-click "Setup.exe" file on the Setup CD-ROM.)
Select the camera to set up and click [Execute].
•
This program searches for the cameras that are connected to the router
and displays the MAC Addresses, IP addresses and Port Numbers.
Click [Automatic Setup (Local Access Only)].
Opens the manuals.
If Adobe
®
Acrobat
®
Reader
is not installed on your PC,
install it from the Adobe Reader
website.
Finishes the Setup Program.
•
When searching for multiple cameras, the cameras can be identified with
the MAC Addresses labeled near the Ethernet (LAN) port of the cameras.
Select a camera.
•
The image is a simulated screen image.
Displays the program version, etc.
When the Single Camera page is displayed, the setup
is completed.
•••
5.
Setup the camera.
Sets up the camera.
Click [Camera Setup].
5.
Setup the camera.
5.
Setup the camera.
5.
Setup the camera.
Important
•
To avoid any possible problems, temporarily disable any firewall or antivirus software.
•
This procedure explains installation of the camera on the same network that your PC is part of.
•
Before proceeding, close your web browser.
Notes
• If more than 20 minutes have passed since the camera was turned on, the camera
cannot be set up from the Setup Program. In this situation, restart the camera.
• The Setup Program may not list any cameras due to your firewall or antivirus soft-
ware settings on your PC. If you cannot disable your firewall or antivirus software,
you can set up the camera entering the camera MAC address on the following win-
dow. See page 13 of the Installation/Troubleshooting for details.
Note
Check [Every visit to the page] for
"Temporary Internet files" on your web
browser. If it is not checked, the camera
may display old images.
•
Click [Cancel] and go to the last page, if you mount the camera.
Click [Next] to set up the Internet access to the cam-
era and go to step on the next page.
Enter the user name and password, and click [Save].
The Enter Network Password window is displayed.
Enter the user name and password that were set, and
click [OK].
Note
Make a note of the user name and password.
NoteNoteNote
•
For the first time installation or after pressing the Factory Default Reset button,
only [Automatic Setup (Local Access Only)] can be selected. To set up the
camera with Static or DHCP settings, after performing the [Automatic Setup
(Local Access Only)], run the Setup Program again and select [Manual Setup].
Installs Network Camera Recorder
Trial Version.
To Next Page
Loading...
