5 of 11
C
AMERA
S
ETTINGS
1. After typing in your user name and password, you will be shown the standard browser interface to
the camera.
2. The system will attempt to install an ActiveX control to show the camera image in the browser
window. This control is not needed for proper OneHome operation, but is needed if you wish to
see the camera image on that computer. If any dialogs appear, close them or accept the ActiveX
control as appropriate for your situation.
3. On Windows computers with popup blocking enabled, you will need to click the appropriate bar to
enable the installation of the ActiveX control.
4. Click Setup at the top to bring up the screen shown below:
To Next Page
Loading...
