21
The underlined values are factory preset setting values.
*1
“AUTO” is set when the monitor is shipped from the factory, but if there are concerns about noise etc. from outside the
input signal, we recommend assigning specific format.
g COMP.
The following menus are switched by selecting “RGB-COMP.” in “YP
BPR/RGB” in the “INPUT SELECT” menu.
The underlined values are factory preset setting values.
*1 “EXECUTING” is displayed while “AUTOSETUP” is being executed, and “COMPLETE” is displayed when
“AUTOSETUP” is completed.
If “AUTOSETUP” cannot be completed, “INCOMPLETE” is displayed.
*2 Each RGB-COMP. input compatible format can be adjusted.
INPUT SELECT
Sub menu Settings Explanation
VIDEO / Y/C
<AUTO>
<NTSC>
<PAL>
Used to select the input format for VIDEO and Y/C input.
*1
<AUTO> Either NTSC or PAL is automatically selected.
NTSC SETUP
<75>
<00>
Selects the NTSC setup level.
<75> Select this when using with a setup signal of
7.5 IRE. (The inner parts of the monitor are set
to the 7.5 IRE setup level to suit the black level)
<00> Select this when there is no setup level signal.
YP
BPR/RGB
<YP
BPR>
<RGB-VIDEO>
<RGB-COMP.>
Selects either YP
BPR (Component) or RGB input mode.
<YP
BPR> Selects the YPBPR signal.
<RGB-VIDEO>
Selects the video RGB signal.
<RGB-COMP.>
Selects the PC RGB signal.
COMPONENT
LEVEL
<SMPTE>
<B75>
<B00>
Selects YP
BPR (Component) signal input level.
<SMPTE> When the signal level specified in SMPTE is
Chroma 100 IRE P
B, PR = 0.7 Vp-p.
<B75> Select this when connecting a betacam or
simliar devices set to 7.5 IRE. (The inner parts
of the monitor are set at 7.5
IRE
setup level to
suit the black level)
<B00> Select this when connecting a betacam or similar
devices that are not setup to the IRE level.
RGB SYNC
<G-ON>
<EXT>
Selects the SYNC when using RGB-VIDEO input.
<G-ON> Select when a synchronizing signal is
superimposed on the G signal.
<EXT> Select when an external synchronizing signal is
received in synchronization.
COMP.
Performs analog PC settings. (Refer to “COMP.” below)
Sub menu Settings Explanation
AUTOSETUP *1 Screen automatic adjustment is performed when “RGB-
COMP.” is selected in “YP
BPR/RGB” in the “INPUT SELECT”
menu. “AUTOSETUP” is performed if a different screen is
displayed, and “YES” is selected.
H POSITION
<0–60>
(Factory preset settings: 30)
Used to adjust the picture display position in the horizontal
direction.
*2
V POSITION
<0–60>
(Factory preset settings: 30)
Used to adjust the picture display position in the vertical
direction.
*2
PHASE
<0–31>
(Factory preset settings:
J page 22)
Used to adjust the clock phase with 1/32 clock phases.
*2
CLOCK
<700–1800>
(Factory preset settings:
J page 22)
Used to adjust the sampling clock in dot units.
*2
WXGA/XGA
<XGA>
<WXGA>
Switches between WXGA and XGA.
Main Menu (continued)
To Next Page
Loading...
