8
When needed, the touchscreen can be configured using the following steps.
Configuring the touchscreen
Touchscreen
Make necessary changes
For more information, refer to [Help].
Click [OK]
2
1
3
NOTE
Select from the taskbar or select [Settings] from [Start] -
[Programs] - [Updd]
The following screen will appear.
Advanced
Hardware
Button Modes
Calibration
Define the calibration setup.
Use when the cursor can not be pointed correctly with
your finger. (Needed if the alignment of the touchscreen
with the visual image change or adjust the display resolu-
tion).
Set the hardware resources.
Match this setting with the
setting for [Base I/O] in the
Setup Utility.
Set the button modes.
Set the advanced settings.
Devices
Configure the device controller.
About
Display the version number.
Status
Display the status of the controller.
Windows
Set the “double-click”
settings.
General
Set the general settings and functions.
Events
Set the events that can be generated
by a controller.
Settings
Set the general protocol
settings.
The touchscreen can be used for only [Whole Desktop] setting in [Devices] -
[Modify] - [logical desktop segment]. This setting is default.
NOTE
To Next Page
Loading...
