54
Security Measures
Setting the Password on boot (enabling, disabling)
1 Run the Setup Utility. (Î page 147)
2 Using either the Î key or the Í key, select [Security].
3 Using either the Ï key or the Ð key, select [Password on boot] and
press the
Enter
key.
4 Select [Enable] or [Disable].
z To enable the Password on boot:
Using the Ï
key or the Ð key, select [Enable] and press the
Enter
key
z To disable the Password on boot
Using the Ï
key and the Ð key, select [Disable] and press the
Enter
key
5 Press the
F10
key and select [Yes], then press the
Enter
key.
Starting Up When the Password on boot is Set
The screen shown at left is displayed.
Enter your password
*1
and press the
Enter
key.
z When the correct password is input, the computer will start
z After 3 wrong password attempts have been made or there is no input for one minute, the
computer will power off
*1
Supervisor Password or User Password set in the Setup Utility (not the Windows password).
To Next Page
Loading...
