Station Preset
Direct Memory
Up to 6 stations can be preset in AM, FM1, FM2, and FM3
respectively.
Preset stations can be simply called up by pressing one of the
preset buttons from [1] to [6].
Auto Preset Memory (APM)
With this operation, stations with good receiving conditions can
be automatically stored in the preset memory.
1
Select a band.
2
Hold down [BAND] (APM) for more than 2
seconds.
The preset stations under best receiving conditions are
received for 5 seconds each after presetting the stations
(SCAN). To stop scanning, press one of the preset but-
tons from [1] to [6].
Note: New stations overwrite existing saved stations.
Manual station preset
1
Tune into a station.
2
Hold down one of the preset buttons from
[1] to [6] for more than 2 seconds.
(blinks once.)
Note: New stations overwrite existing saved stations.
You can assign your favorite broadcasting station to the
[D•M] (Direct Memory) button. As the result of doing that,
your favorite broadcasting station can be received even if the
unit is turned off, or the CD mode is activated.
D•M station calling
1
Press [D•M].
Press again to cancel.
D•M station writing
1
Select a station you would like to preset.
2
Hold down [D•M] for more than 2 seconds.
Display change
Press [DISP] to change the display.
Radio source display (Default)
Radio Source Display
Clock display
lights while receiving an FM stereo signal.
Band Preset NumberFrequency
lights while receiving the D•M station.
To Next Page
Loading...
Need help?
General
