Panasonic CQ-C3401 - General; Each Source

OPEN
DISC
SCROLL
PWR
MUTE
RANDOM SCAN REPEAT CLOCK
F
O
L
D
E
R
V
O
L
U
M
E
P
U
S
H
S
E
L
T
U
N
E
/
T
R
A
C
K
CQ-C3401W
213
SRC
SQ
45 6
DISP
BAND
APM
SRC
SQ
DISP
8 9
7
E
N
G
L
I
S
H
8
E
N
G
L
I
S
H
CQ-C3401WCQ-C3401W
General
Volume
Note:
¡ The volume level can be set independently for each
source. (For radio, one volume setting for AM, one vol-
ume setting for all FMs)
Mute/Attenuation
ON : Press [MUTE].
OFF : Press [MUTE] again.
You can select mute or attenuation. (a Page 20)
Clock Display at Power Off
When the power of the unit is set to OFF, press [DISP].
(Clock time) (Default)
(Display off)
When the power is set to ON, refer to the description for
each source mode.
SQ (Sound Quality)
SQ is a function that can call up various sound types at the
touch of button in accordance with your listening music
type.
Press [SQ] to select the sound type as follows:
Press [DISP] to return to the regular mode.
Note:
¡ Settings of SQ, bass/treble and volume are influenced
one another. If such an influence causes distortion to
the audio signal, readjust bass/treble or volume.
(a Page 20)
(VOCAL) clear sound:
emphasizes middle tone and slightly
emphasizes treble.
(POP) wide-ranged and deep sound:
slightly emphasizes bass and treble.
(ROCK) speedy and heavy sound:
exaggerates bass and treble.
(FLAT) flat frequency response:
does not emphasize any part. (Default)
Up
Down
[DISP] (Display)
[MUTE] (Mute/attenuation)
[SQ] (Sound Quality)
Default: 18
Setting range: 0 to 40
[SRC: Source] (PWR: Power)
Power
Set your car’s ignition switch to the ACC or ON position.
ON: Press [SRC] (PWR).
OFF: Press and hold [SRC] (PWR) for more than 1
second.
Note:
¡ If you turn the key to the ACC OFF position during the
security function is active, the security message appears
with a warning alarm. (Default: SLED ON)
(a Page 22 about security function setting)
Remote control sensor (a Page 6)
indicator
[VOLUME]
Source
Press
[SRC]
to change the source.
Radio
CD Player
MP3/WMA Player
CD Changer Control
AUX
Note:
¡AUX cannot be used when the CD changer is connect-
ed to the DIN connector.
(Sound source connecting
to the AUX input terminal
a Installation Instructions)
(AUX ON/OFF Selection
a Page 22)
(When the optional CD
changer is connected
a
Page 18)
(When an MP3/WMA data
disc is in the player
a
Page
14)
OR
(
a
Page 13)
(
a
Page 10)
OR
CD Player Mode Display (
a
Page 13)
Level Meter (
a
Page 22)
indicator