Panasonic CQ-C3401 - Radio

OPEN
DISC
SCROLL
PWR
MUTE
RANDOM SCAN REPEAT CLOCK
F
O
L
D
E
R
V
O
L
U
M
E
P
U
S
H
S
E
L
T
U
N
E
/
T
R
A
C
K
CQ-C3401W
213
SRC
SQ
45 6
DISP
BAND
APM
21 3
SRC
4 5 6
DISP
BAND
APM
10 11
9
E
N
G
L
I
S
H
10
E
N
G
L
I
S
H
CQ-C3401WCQ-C3401W
q
Radio Mode
Press [SRC] to select the radio mode.
w
Band
Press [BAND].
e
Tuning
[[]: Higher frequency
[]]: Lower frequency
Press and hold [[] or []] for more than 0.5
seconds, then release it. Seeking will start.
Display Change
Press [DISP] to change the display as follows.
Radio
[BAND]
(APM: Auto Preset Memory)
[DISP] (Display)
Preset Buttons [1] to [6]
(Preset station)
[]][[] (TUNE)
Band Frequency
Preset number
F
requency
Clock time
Auto Preset Memory (APM)
With this operation, stations with good receiving condi-
tions can be automatically stored in the preset memory.
q Select a band. (a Previous page)
w Press and hold [BAND] (APM) for more than 2 sec-
onds.
6 stations with first to 6th highest in signal strength will
be preset to each band.
Once set, the preset stations are sequentially scanned
for 5 seconds each. (scanning)
Note:
¡ To stop scanning, press one of the buttons from [1] to
[6].
Manual Preset Memory
With this operation, a station can be manually stored in the
preset memory.
q Select a band and frequency. (a Previous page)
w Press and hold one of the preset buttons from [1] to [6]
until the display blinks once.
Preset number
Station Preset
Up to 6 stations can be stored in each of the FM1, FM2, FM3 and AM band selections.
Note:
¡ New stations overwrite existing saved stations after these procedures.
Warning
¡To ensure safety, never attempt to preset stations while you are driving.
Preset Station Calling
q Select a band. (a Previous page)
w Press one of the preset buttons from [1] to [6].
[SRC: Source]
(Stereo) indicator